Soften Easy Tray wafer in thermal unit/hot pot by immersing in water for at least 30 seconds. Water temperature must be 170°F (77°C) or hotter.

Using tongs, remove Easy Tray wafer from water.

Cut with scissors to desired size.

Mold Easy Tray material over the disposable fluoride tray.

Place fluoride tray with adapted Easy Tray into patients mouth to check fit.

Remove both spacer material and custom impression tray simultaneously as a unit and place under cold tap water, until hard (about one minute).

Remove spacer material and dry custom tray with air syringe.

Easy Tray is now dimensionally stable and ready to use.

Paint the internal surface of the custom tray with the adhesive that is recommended for the impression material that you are using.

You are now ready to take your impression.